Introduction
The Power Probe Professional Electrical Test Kit provides the circuit testing ability of the Power Probe 3 combined with the diagnostic capabilities of the Power Probe Digital Multimeter.
Features
PP3
DMM
| PP3 | |
| – DC 0 – 70V + 1 digit
– P-P 0 – 70V |
|
| Frequency response of tone pass through | |
| – 10Hz to greater than 10 Khz | |
| PP display | |
| – 15Hz Square Wave
– 35Hz Sine Wave |
|
| Power Probe Mode – Continuity to ground | |
| – First level – display is enabled less than 20K
– Second level – green LED is enabled less than 2K |
|
| – & + Peak Detector Response | |
| – Single event capture less than 200μs pulse width
– Repetitive events less than 1μs pulse width |
|
| Peak to Peak Mode | |
| – 0 – 70V + 1 digit
– 4Hz to over 500kHz Square Wave input – 4Hz to over 250kHz Sine Wave input Threshold for PPAC/Audible passthrough |
|
| Circuit Breaker | |
| 8 amp thermal response – Manual reset
Typical Response
|
|
|
DMM |
|
| Operating Altitude | 2000m |
| Relative Humidity | 75% max operating |
| Operating Temperature | 0°C~40°C/32°F~104°F (<80% RH) |
| Storage Temperature | -10°C~60°C/14°F~140°F (<70% RH) |
| Accuracy Temperature | -18°C~28°C/64°F~82°F (<80% RH) |
| Temperature Coefficient | 0.1x(specified accuracy)/°C (<18°C or >28°C) |
| Sampling Frequency | approx. 3 times/sec. |
| Fuse Protection | μA/mA input: F600mA/600V 10A input: F10A/600V |
| DC/AC Voltage | 600V |
| DC/AC Current | 10A |
| Resistance | 60MΩ |
| Capacitance | 60mF |
| Frequency | 10kHz |
| Diodes | 2.7V |
| Continuity | <50Ω |
| Temperature | -20°C~1000°C/-4°F~1832°F |
| LCD Display | 3 ¾ digit display (6000 counts) |
| Product Supply | 3×1.5V AAA batteries |
| Product Size | 160mmx74mmx49mm / 6.3″x2.9″x1.9″ |
| Product Weight | 482g / 1.06lb |
| Safety Rating | CAT IV 600V |
| Safety Standards | IEC61010-1 |
| Pollution Degree | 2 |
| Accuracy | ±(of reading + # of least significant digits) |
